On a side note, I was trying to determine the Input PWM frequency of the lasers I have Then I'll make the parser do those as well if you supply a raster\vector Gcode file.ĭavid, the Impact engraving thread was a good read. I'll then look at the Gcode to see what needs to be done to convert it to Mach3.Įddy and David, if you have any preference for some other software that you likeĪnd outputs GRBL or any of the Arduino based controllers smoothie ect then If you have the software (and the trials not over) could you make two smallġ.A raster graphics one, perhaps a 2 x 2 inch I just need to see the Gcode.Ģ.Another one with vector graphics in it the same size. I'm not sure if Lightburn does this for the trial version, in any case Bubba
The trial program won't save Gcode and puts watermarks in the file. Use Corel\Inkscape as one of the preferred methods for Image manipulation I went to the T2 site and the software looks pretty good, they do recommend to I suppose it's really whether on not you like the interface.
I visited those sites, and the one Bubba pointed to, that software could be usedĪs it has a Mach3 PP (Tweaky's handiwork I think).
0 kommentar(er)
